Date post: | 01-May-2015 |
Category: |
Documents |
Upload: | taddeo-di-stefano |
View: | 213 times |
Download: | 0 times |
Università degli Studi di Pisa
Milestone primo anno
M1.1 Sviluppo di un codice per la simulazione del trasporto e del rumore shot in strutture mesoscopiche, in presenza di droganti distribuiti casualmente, con l’utilizzo di potenziali di confinamento realistici
M1.2 Messa a punto di un sistema di misura a bassissimo rumore operante a temperature criogeniche, sfruttando tecniche di correlazione e il metodo dell’impedenza sostitutiva…
M1.3 Misure di rumore shot su dispositivi a doppia barriera a effetto tunnel risonante, con particolare attenzione alle condizioni di funzionamento con correnti estremamente basse, che possono essere investigate per la prima volta con il sistema di misura
Università degli Studi di Pisa
Situazione del personale
E’ stata bandita, con un certo ritardo per motivi burocratici, la borsa connessa con il progetto: l’assegnazione della stessa dovrebbe essere fatta lunedi’ prossimo
Nel frattempo una persona ha cominciato a lavorare sul progetto in aprile, su fondi residui CNR
Anche l’attivita’ di un tesista (laurea specialistica) e di un dottorando si inquadrano all’interno del progetto
In parte vi rientra anche quella di un’assegnista di ricerca (al 15% circa)
Università degli Studi di Pisa
Drain
metalPoly
Motivation for the present study
The 1/3 suppression has been experimentally demonstrated for metallic diffusive wires: M. Henny et al., PRB 59, 2871 (1999)
Only one experiment exists on diffusive semiconductor nanostructures, and its results are not conclusive: F. Liefrink et al., Phys. Rev. B 49, 14066 (1994)
L We have developed a numerical
model of conductance and noise in a quantum wire, to understand whether the diffusive regime can actually be achieved
Some adjustable parameters have been tuned based on measurements performed on a test structure
Università degli Studi di Pisa
General approach
Development of a 3D Schrödinger-Poisson solver to provide the confinement potential
Inclusion of the effects of discrete dopants Development of a 2D transport simulator suitable for the
investigation of conductance and noise Fabrication of a suitable sample quantum wire Measurement of sample conductance vs. gate voltage Calibration of the simulator based on experimental data Calculation of noise and of the expected Fano factor Measurement of shot noise in the sample quantum wire
Università degli Studi di Pisa
Device structure
Università degli Studi di Pisa
Potential calculation
Poisson equation
The electron density n() in the quantum region is obtained from the solution of the Schrödinger equation with density functional theory
p(), ND+(), NA
-() and of n() out of the quantum region are given by the corresponding semiclassical expressions
)(N)(N)(p)(nq)r( DA
Discretization with the box integration method Newton-Raphson technique with predictor-corrector iteration scheme
Università degli Studi di Pisa
3D Poisson-Schrödinger solver
1st step: Non linear Poisson equation in 3D The strong confinement in the x direction, perpendicular to the
heterointerface, allows us to decouple the Schrödinger equation into
a 1D equation in the x direction,
a 2D equation in the y-z plane. The density of states in the y-z plane is well approximated by the semiclassical expression.
The boundary condition at the semiconductor-air interface is treated assuming a uniform density of surface states Ds, which behave as donors or acceptors depending on their position (below or above) relative to an effective work function * (set to 4.85 eV). The electric field is assumed to vanish in the air.
)]()()()([)( DA NNpnqr
Università degli Studi di Pisa
Discrete donors
We use a semi-analytical technique to include the effect of discrete donors (otherwise the discretization grid would be prohibitively large)
a)
b)
c)
d)
Screening is included following Stern and Howard, PRB 163, 816 (1967)
Università degli Studi di Pisa
Confinement potential
Computed potential Longitudinal cross-section
Università degli Studi di Pisa
Conductance and noise calculation
The transmission matrix is computed with a recursive Green’s function technique
Università degli Studi di Pisa
Averaging details
The expression for the Fano factor must be modified if the temperature is different from zero
Averaging must be weighted with the derivative of the Fermi function instead of performing it over an ensemble of devices, as it has been often done in the literature
Università degli Studi di Pisa
Conductance comparison
Parameters have been adjusted to match the conductance curves
Ns=1.13 x 1012 cm-2; Ds=0.5 x 1014 m-2 eV-1
Università degli Studi di Pisa
Noise results
This is consistent with a results for a soft-obstacle model (Macucci et al., to be published in PRB, 2002)
Università degli Studi di Pisa
Stretched potential
L=1 m L=3 mL=5 m
Calculations have been repeated for stretched wires, extending the length of the middle section before adding the contribution from the discrete dopants
Università degli Studi di Pisa
Conclusions and future work
Good agreement has been obtained between the numerical and the experimental conductance, by adjusting donor concentration and surface defect concentration
Noise results show that, due to the relatively small amplitude of the potential fluctuations, a diffusive regime is not reached or, at least, is not a common occurrence
Stretched wires exhibit a similar noise behavior, demonstrating that failure to reach the diffusive regime is not due to the length of the device being less than the elastic mean free path
A better screening model can be developed from numerical calculations on a single impurity with a very fine mesh
The feasibility of noise measurements to validate the model is being assessed
Università degli Studi di Pisa
Sistema di misura Il tubo in acciaio inox che
contiene l’intero sistema e’ posto all’interno del dewar in modo che il campione si trovi alcuni millimetri al di sopra del livello del liquido criogenico
Università degli Studi di Pisa
Aspetti in corso di miglioramento
Il principale problema, nel corso delle misure a bassi valori di corrente, sembra essere rappresentato dalle vibrazioni meccaniche
Sono stati tentati vari tipi di supporti antivibranti, con esiti alterni
Da misure di spostamento relativo appare che grossa parte dei disturbi vengono trasmessi dal pavimento
Si e’ quindi pensato di realizzare un supporto di tipo pneumatico, basato su componenti di un tavolo antivibrante gia’ disponibile
Università degli Studi di Pisa
Tavolo antivibrante
Università degli Studi di Pisa
Supporto antivibrante per dewar
Università degli Studi di Pisa
Status criostato a diluizione
La consegna e’ in ritardo, per il momento sono arrivate solo le foto…
Università degli Studi di Pisa
Risultati delle misure in corsoSono in corso misure nella regione a basse correnti di diodi resonant tunneling, per cercare di individuare l’effetto della transizione tra l’effetto coulombiano e l’effetto Pauli
Università degli Studi di Pisa
Nuovi risultati per il rumore in cavita’